Powerpole Distribution: Difference between revisions
From SUWS-wiki
No edit summary |
No edit summary |
||
| Line 19: | Line 19: | ||
* 6 power-pole connectors | * 6 power-pole connectors | ||
* Individually fused connections with indicators | * Individually fused connections with indicators | ||
* 30A | * 30A capacity (Limited by current rating of the fuse holders) | ||
=== Costings === | === Costings === | ||
Revision as of 15:31, 14 July 2017
| Powerpole Distribution Box Project | |
|---|---|
| |
| Status | Completed |
| Project Lead | User:TylerWard |
Powerpole Distribution Box Project
A DC power distribution board using Anderson powerpole connectors
Status
- Completed, designs are available at Github
Feature List
- 6 power-pole connectors
- Individually fused connections with indicators
- 30A capacity (Limited by current rating of the fuse holders)
Costings
Costings below are for individual orders the main club order will be cheaper
| Type | Item | Cost | Link |
|---|---|---|---|
| connector | 12*45A pcb contacts | £9.90 for 15 | [1] |
| connector | 6* red 45A housings | £2.65 for 10 | [2] |
| connector | 6* black 45A housings | £2.65 for 10 | [3] |
| Fuseholder | Keystone 3522 | £6.56 for 100 | [4] |
| Resistor | 330ohm though hole 0.25w | £0.23 for 10 | [5] |
| LED | 3mm red/yellow | £0.24 for each | [6] |
| PCB | 5*10cm 2oz blue | $40.95 for ~10 or (£3 each) | [7] |
Build instructions
Tools Required
- Soldering Iorn (Should be a high power Iron (45W+) with a large tip do that it has a large thermal mass)
- Sidecutters
- (Usefull) Helping hands or other PCB support tool.
Instructions
- Solder resistors capacitors and LEDs onto the PCB.
- Push Fuse holder contacts into pcb
- Solder Fuse holder contacts, these will suck up the heat so might take a bit to get up to temperature.
- Assemble to top two case layers and attach the partly populated PCB
- Assemble the powerpole contacts by joining them together and inserting the contacts.
- Place the powerpole contacts into the board (to ensure correct placement ensure the top acrylic layers are fitted first othwerwise the spring of the powerpoles will mean they go in off centre).
- Solder the powerpole contacts on the board, I found the best way to do this is to push the board and contacts down onto a heatproof surface so that they sit in the correct place and then solder, these should be soldered fairly quickly as the powerpole housings can be melted if exposed to to much heat.
- Check for any solder bridges across the fuses or powerpoles.
- Assemble the remaining two layers of the case.
- Enjoy your Distro
